We did some testing on the LOR LYNX combination of controllers. I had a LYNX Dongle,  VIXEN for the Sequencing software.  A Lynx express, a Lynx SSR and several LOR controllers.

First we had connected the dongle to each individual device to make sure each one operated.  OK ..

Then we set the addresses in 2 of the LOR Controllers 1 (1 thru 16) and 9 (129 thru 144).  The crossover cable between the DONGLE and the LOR box worked.

We set the LYNX box to 1 through 16 as well to see if that was possible .. Basically doubling the ampacity of channels 1 through 16.  So now the connection is from LYNX Dongle to the IN side of LOR controller via Crossover.  Then OUT the LOR via crossover cable went to IN LYNX.  That worked so then we connected the SSR to the OUT side of the LYNX controller.  Again no problem and tested OK

Then we added in a second LOR controller the the OUT side of the SSR.  Again we needed a Crossover cable.  it all tested great.

So bottom line as long as we use the right cabling, and crossing over to the different controller types we were fine in building up the DMX Controller Universe.

Notes to self .. keep in mind the LOR controller numbering scheme.  Make sure your crossovers are correct.

Now where is that 6 foot circle I need to build?